How To Use Vax Dual Power Carpet Cleaner
Introduction
Keeping your carpets clean and looking fresh can be a daunting task, especially if you have pets or young children. Removing dirt, stains, and odors from your carpets can seem like an impossible challenge, but with the Vax Dual Power Carpet Cleaner, the process becomes much easier and more efficient. In this article, we will guide you through the steps of using the Vax Dual Power Carpet Cleaner to ensure your carpets remain in pristine condition.
Step 1: Prepare the Machine
Before you start cleaning your carpets, it’s essential to prepare the Vax Dual Power Carpet Cleaner. Begin by filling the clean water tank with hot tap water. Make sure not to exceed the maximum water level indicated on the tank. Next, add the recommended amount of Vax carpet cleaning solution to the tank. This will help in breaking down stains and odors.
Step 2: Pre-treat Stains
If your carpets have stubborn stains or high-traffic areas, it’s recommended to pre-treat them before running the Vax Dual Power Carpet Cleaner. Spray a small amount of Vax pre-treatment solution onto the affected areas and gently rub it in using a soft brush. Allow the solution to soak for a few minutes to loosen the stubborn stains.
Step 3: Adjust the Settings
The Vax Dual Power Carpet Cleaner offers multiple settings to customize your cleaning experience. Look for the settings dial on the machine and choose your desired mode based on the carpet condition. For regular cleaning, the ‘Wash’ mode is suitable, while the ‘Rinse’ mode helps remove any detergent residue after washing.
Step 4: Begin Cleaning
Now that you have prepared the machine and adjusted the settings, it’s time to start cleaning your carpets. Begin by plugging in the Vax Dual Power Carpet Cleaner and turning it on. Slowly push the machine forward while simultaneously pressing the trigger under the handle. This will release the cleaning solution and water onto the carpet. Continue to push and pull the machine in straight lines, covering the entire carpet surface.
Step 5: Refill and Empty
When the clean water tank is empty or the dirty water tank is full, it’s time to refill and empty the Vax Dual Power Carpet Cleaner. Turn off the machine and unplug it from the power source. Empty the dirty water tank by removing it from the machine and pouring the collected dirty water down the drain. Rinse the tank thoroughly to remove any residue.
To refill the clean water tank, remove it from the machine and unscrew the cap. Fill the tank with fresh hot tap water up to the indicated maximum level and add the appropriate amount of Vax carpet cleaning solution. Once the tank is filled, securely screw the cap back in place and reattach it to the machine.
Step 6: Dry the Carpets
After you have cleaned the entire carpet surface, it’s important to help the carpets dry quickly. Open windows or turn on fans to improve air circulation in the room. Avoid stepping on the freshly cleaned areas while they are still damp to prevent any potential stains or damage. Depending on the carpet thickness and humidity, drying may take a few hours, so be patient.
Conclusion
The Vax Dual Power Carpet Cleaner is a versatile and efficient tool for maintaining clean and fresh carpets. By following these simple steps, you can effectively remove dirt, stains, and odors from your carpets with ease. Remember to always read the instruction manual provided by Vax for specific guidance and additional tips. With the Vax Dual Power Carpet Cleaner, your carpets will look and feel brand new!