Introduction
Thermal lining paper is an excellent addition to your home decor, providing insulation and helping to reduce heat loss. Hanging thermal lining paper might seem like a daunting task, but with a little bit of guidance, it can be a straightforward and satisfying DIY project. In this article, we will guide you through the steps on how to hang thermal lining paper, so you can enjoy a warm and cozy home.
Gather the Necessary Supplies
Before you dive into the project, it’s important to gather all the supplies you will need. Here’s a list of what you’ll need:
1. Thermal lining paper rolls
2. Wallpaper adhesive
3. Measuring tape
4. Scissors
5. Wallpaper brush or roller
6. Spirit level
7. Seam roller
8. Smoothing brush
9. Pencil
10. Wallpaper paste brush
Ensure that you have all these supplies handy before you begin, as it will make the process much smoother.
Prepare the Walls
Before hanging the thermal lining paper, it is imperative to ensure that your walls are clean, dry, and smooth. Any existing wallpaper, peeling paint, or loose plaster should be removed or repaired before proceeding. Use a filling compound to patch up any cracks or holes in the walls, and sand them down for a smooth surface. Wiping the walls with a damp cloth will remove any lingering dust and debris.
Measure and Cut the Thermal Lining Paper
Measure the height of your walls using a measuring tape. Add a couple of inches to the measurement to allow for trimming and adjustments. Lay the thermal lining paper on a flat surface and use scissors to cut it to the required length. Remember to mark each roll of paper with a pencil indicating the order of hanging (e.g. 1, 2, 3).
Mix the Wallpaper Adhesive
Follow the instructions on the wallpaper adhesive packaging to mix the adhesive properly. Ensure that it is thoroughly mixed to avoid any lumps or inconsistencies. Let the adhesive sit for the specified time to activate, according to the manufacturer’s instructions.
Apply Adhesive
Apply a generous amount of wallpaper adhesive to the back of the first cut strip of thermal lining paper, using a wallpaper paste brush. Start from the top of the strip and work your way down, ensuring that the adhesive covers the entire surface evenly.
Hang the Thermal Lining Paper
Carefully align the top of the first strip of thermal lining paper with the wall, ensuring it is straight. Use a spirit level to double-check the alignment. Slowly press the paper against the wall, starting from the top and working your way down. Smooth out any air bubbles or wrinkles using a smoothing brush or a wallpaper brush/roller.
Repeat the Process
Continue the process of applying adhesive to each strip of thermal lining paper and hanging it onto the wall, ensuring that the edges are tightly butted together. Use a seam roller to press down the edges for a seamless finish. Remember to remove any excess adhesive immediately with a damp cloth to prevent it from drying on the surface.
Finishing Touches
Once all the strips are hung, allow the thermal lining paper to dry completely. This can take a few hours, depending on the drying time recommended by the adhesive manufacturer. Use a sharp utility knife or scissors to trim any excess paper from the edges and around outlets or switches.
Conclusion
Hanging thermal lining paper may seem like a complex task initially, but with the right supplies and step-by-step instructions, it can be easily accomplished by anyone. By following these simple guidelines, you can give your home an added layer of insulation and enjoy a more energy-efficient and comfortable living space. So, go ahead and give it a try – you’ll be amazed at the difference thermal lining paper can make!